BOOSTER (1KG)

COVERAGE:

• Approximately 75 to 210 sq. ft. (7 m2 to 20 m2) per kilogram depending on method of application and procedure followed

METHOD OF APPLICATION:

• Read entire label before using
• TEST A SMALL AREA, according to application instructions, to determine desired results

FOR REMOVING EMBEDDED STAINS:

• Mix 38 to 88 grams of BOOSTER with the recommended ADDITIVE, Solvent, or Chemical liquid to form a thick, workable paste.
• Apply a 1/4-inch (6 mm) thick layer of paste directly over the stain, extending at least 1 inch (25 mm) beyond the edge of the stain.
• Cover with plastic film or wax paper if the surface is subject to foot traffic.
• Allow the paste to sit on the stain for 24 hours or until completely dry.
• Carefully remove the BOOSTER without scratching the surface and wash off any residue with Floor Medics Stone Cleaner.
• Repeat the procedure if necessary.

FOR REMOVING OF TEXTURED SURFACE STAIN ON TILES AND STONES:

• Protect surrounding areas from splattering to minimize cleanup.
• Apply Recommended Chemical on surface and sprinkle BOOSTER onto a manageable area making a thin slurry.
• Spread mixture on small section of about 10 sq. ft. (1 m2) and agitate with a white pad or with low RPM (175- 300 RPM) Scrubbing machine, using a white nylon scrub pad. Keep surface wet throughout buffing process.
• Remove BOOSTER solution with clean towels or sponge and rinse twice with clean water. A wet-dry vacuum may be used.
• Polish surface dry with clean, dry towels or buff with soft buffing pad.
• On vertical or countertop surfaces, hand apply BOOSTER slurry, scrubbing with white nylon scrub pad. Rinse with clean water and buff dry with clean towels.

LIMITATIONS:

• Extreme care should be taken with Polish marble as they are normally softer surface
• Light abrasive action or high RPMs on the surface of these marbles may dull the high polished finish
• Do not allow BOOSTER to come in contact with any non-recommended surface

For more information, kindly upload Technical Bulletin